Great Wall ISO VG 100 Piston Type Vacuum Pump Oil for Laboratory Vacuum Drying Ovens
Piston Vacuum Pump Oil
,ISO VG 100 Vacuum Oil
,Laboratory Oven Pump Oil
Great Wall ISO VG 100 Piston Type Vacuum Pump Oil for Laboratory Vacuum Drying Ovens
In a laboratory vacuum drying oven, oil vapor in the chamber is a contamination risk, not just a vacuum problem. Samples that sit under a pump film for hours can pick up hydrocarbon traces, and any back-streaming shows up later as invisible contamination on glassware, on filters or in analysis results. Sinopec Great Wall ISO VG 100 vacuum pump oil is blended for piston and rotary piston mechanical pumps that hold ovens, drying cabinets and pre-freeze stages at working vacuum for long unattended runs.
Why This Grade Suits Laboratory Ovens
- Low saturated vapor pressure: 1.09 × 10-3 kPa at 20°C limits oil vapor release into the chamber, which matters most during long, hot, low-pressure holds.
- Stable sealing over long runs: the refined mineral base keeps a sealing film on piston rings and cylinder walls, so vacuum holds overnight instead of creeping up.
- Clean oil-water separation: water driven off wet samples drops out and drains instead of forming an emulsion that degrades the film.
- Oxidation stability: resists sludge and varnish during weeks of continuous duty at elevated pump temperature.
- Controlled foaming: prevents oil carryover during rapid evacuation at cycle start.
Typical Data
| Item | Great Wall ISO VG 100 |
|---|---|
| ISO Viscosity Grade | 100 |
| Kinematic Viscosity at 40°C, mm²/s | 99.45 |
| Flash Point (Open Cup), °C | 268 |
| Pour Point, °C | -9 |
| Saturated Vapor Pressure at 20°C, kPa | 1.09 × 10-3 |
| Specification | SH/T 0528-92 |
Typical data are representative values from standard test conditions and do not constitute a specification.
Typical Applications
- Piston and rotary piston vacuum pumps on laboratory vacuum drying ovens
- Vacuum drying cabinets, desiccators and sample preparation lines
- Pre-stage pumping ahead of freeze drying and rotary evaporation
- Filtration, degassing and impregnation benches in research laboratories
- Replacement fill for pumps originally specified on ISO VG 100 vacuum pump oil
Product Q&A
Q1: Can oil vapor contaminate samples in a drying oven?
A: Yes. Pump oil with high vapor pressure releases hydrocarbon vapor that can migrate back into the chamber. A low vapor pressure grade such as this ISO VG 100 product keeps that release small, which is why it is specified for laboratory work rather than general industrial duty.
Q2: How often should the oil be changed in a laboratory oven pump?
A: Follow the pump maker’s interval, then let oil condition decide. Sample for water content and viscosity change, and change immediately if the oil turns milky, because moisture is the most common failure route when drying wet samples.
Q3: Does this oil suit rotary vane pumps as well as piston pumps?
A: Yes. It is recommended for all mechanical vacuum pumps — piston, rotary piston and rotary vane — wherever a 40°C kinematic viscosity of about 100 mm²/s is specified.
Supply and Packing
Supplied as 200 L steel drums or 20 L plastic pails in export-grade packaging, with technical data sheets and batch certificates on request. Stock orders ship in about seven working days; production orders typically take 15 to 25 days. Contact us for bulk pricing and help choosing the right viscosity grade for your pump model.
Please Use Our Online Inquiry Contact Form Below If You Have Any Questions, Our Team Will Get Back To You As Soon As Possible